How to Choose Flood Lights and Facade Lighting in the UAE
Good flood and facade lighting comes down to five decisions: the purpose of the lighting, the luminaire power, the beam angle, the protection rating and the control method. This guide walks through them in order.
1. Start with the purpose
- Security and surveillance: strong, even light in neutral or cool white, because CCTV cameras perform better with it.
- Car parks, yards and outdoor storage: medium to high power luminaires with a wide beam.
- Architectural facade accent: warm or neutral light, with luminaires that build up detail rather than flooding the building.
- Paths and gardens: low-power, soft light that does not glare.
2. Choose the right power
Flood lights range from about 4 W for entrances and paths to hundreds of watts for large yards. Our catalogue includes flood lights at 4-10 W, 50-200 W and 400-600 W, all rated IP66. Do not choose power by guesswork. What matters is the light level needed on the area, which is calculated with lighting software such as DIALux. Also compare efficacy: a luminaire at 130 lm/W produces far more light than one at 100 lm/W at the same wattage.
3. Beam angle
- Narrow (15-25 degrees): trees, columns and tall buildings lit from a distance.
- Medium (30-60 degrees): building facades lit from a moderate distance.
- Wide (over 60 degrees): car parks and open yards.
A narrow beam used too close gives a harsh, uneven hotspot. A wide beam used from far away wastes light outside the target.
4. IP rating and build quality
In the UAE, dust, humidity and summer heat all act on an exterior luminaire. We recommend IP65 as the minimum, and IP66 for roofs, car parks and wash-down areas. Pay attention to materials too: die-cast aluminium housings cool the luminaire better, and stainless-steel fixings resist corrosion in humid or coastal air.
5. Colour of light
- 3000K: stone facades, premium buildings and villas.
- 4000K: commercial buildings and walkways.
- 5000K: car parks, warehouses and surveillance areas.
Consistency matters more than the exact value: use one colour temperature across a facade, and ask for SDCM below 3 when buying many luminaires.
6. Controls and saving energy
- Photocell or timer: switches lighting on at dusk and off at dawn.
- DALI or 0-10V dimming: reducing output after midnight saves energy and extends life.
Some models support dimming and others do not, so confirm this before purchase. Changing the driver after installation is expensive.
7. Facade lighting: practical notes
- Aim light downward or at a calculated angle to limit glare and light pollution.
- Avoid direct flat lighting on glass facades.
- Use grazing light close to the surface to bring out stone texture, and a greater distance to wash the surface evenly.
- Leave final distances and angles to a photometric calculation for each project.
Frequently asked questions
Is IP65 enough for an outdoor flood light? Yes for walls and facades. IP66 is preferable for roofs, car parks and wash-down areas.
What power do I need for a large area? It is set by a photometric calculation based on area, mounting height and required light level, not by guesswork.
Will the luminaire handle UAE summer heat? Check the operating temperature range on the datasheet and prefer die-cast aluminium housings for cooling.
Browse related products
Flood lights · Architectural and facade lighting · Urban and street lighting
Send us your project drawings and we will provide a photometric calculation and a quotation. Request a quote.
Also read: LED Lighting Specifications Explained.